All about Depo lights

Depo lights are well-known to us for their quality and durability. If you want to install a light in your vehicle and you need to consider Depo light, the process is much like any other light installation. While you can surely bring your car into a repair shop to have this done, you can cut your budget doing the job yourself. You can do finish this job in about a half an hour with nothing more than a screwdriver. Today, let's talk about how to install depo headlights and how to wire depo tail lights.

The Way of Installing Depo Headlights

The whole installation of depo headlights is similar to their lights'. First, check the depo headlight assembly. And figure out see the light with attached side brackets and package of head screws. You should make sure the depo your got fits your car when purchasing it.

Second, open the hood of your car. Remove the faulty headlight so that the new depo one will be installed. Insert the new headlight into your car. Align the brackets with the screw holes in the well. Secure the assembly in place with the screwdriver.

Third, you should attach the electric cable to the rear of the headlight assembly. This cable will have a plug or plastic end which will need its sides squeezed to be pushed into place. This is an important process which will connect the new depo headlight to your car electrical system. Then, lower the hood and do not forget to test the new depo headlight.

The Way of installing Depo Tail Lights

Replacing tail lights with LED lights increases the visibility of your vehicle. It is obviously that LED tail lights are brighter than OEM ones. The LED draws less power and can last more than 10 years. Depo makes a selection of LED tail lights to fit many models and makes of vehicles. For that the depo tail lights are designed to take advantage of the car's existing tail light plugs, the way to wire depo tail lights is very easy.

First, open the rear hatch or your car. Remove the trunk carpet that prevents your access to the tail lights. If your car has panel screws, you should use a socket driver to remove them.

Second, you need to grab the electrical connector and turn it counterclockwise. And then pull the bulb and connector out of the tail light assembly. Then install the tail light bulb back into the connector and turn the bulb counter-clockwise until it releases so that you can remove the bulb from the connector.

Third, install the tail lights in the holding ring. Connect the wire plug harness to the tail light by pushing the two plugs together. Put the trunk covering back. And then use the same steps to install the depo tail lights on the other side.

I hope all information mentioned about depo headlights and depo tail lights above are of use. I believe if you have the ability to install your car lights by yourself, you will save a little bit of money and most importantly, you may enjoy the process of installation.